Tool Specials

FORD 6.4L DIESEL TURBO ARM PULLER

This tool has been designed to remove the actuator link rod from the arm on the turbo of the 2008 to 2010 6.4L Ford power stroke diesel engine.
$45.00

DURAMAX TURBO VANE POSITION SENSOR SOCKET

This tool has been designed to remove the turbo vane position sensor on late 2004 to present GM medium-duty trucks with Duramax engines, also works on light-duty trucks and ISUZU diesel F-series medium-duty trucks.
$45.00

GM DURAMAX WATER IN FUEL SENSOR WRENCH

When replacing the fuel filter on a 2001 to current GM DURAMAX light duty truck the water-in-fuel sensor located in the bottom of the filter must be removed and reused in the new filter. This wrench has two sides, one designed to fit the odd shaped 40mm 12 sided sensor found on 2001 to 2010 trucks, the other end fits the 42mm 6 sided sensor on the 2011 to current trucks.
$32.00

DURAMAX LLY, LBZ, LMM INJECTOR PULLER KIT

This tool has been designed to remove the diesel injectors from GM vehicles produced from 2005 to 2010 with an LLY, LBZ, or LMM Duramax engine.
$119.00

FUEL LINE SOCKETS FOR CUMMINS ENGINES 22mm & 19mm

The 22mm 1/2-inch-drive socket is designed for the Cummins ISX engines. The 19mm 1/2-inch-drive socket is designed for the Cummins ISB engines.
$69.00

DURAMAX FAN PULLEY HOLDER

Easy access. Ample leverage. 20″ length design provides leverage, easy handling and reduces service time. Efficient design. Easily hold the fan pulley without damaging the pulley or bearing.
$69.00

Domestic Diesel Fan Clutch Wrench

4 Pin Fan Clutch wrench used on domestic diesel vehicles.
$69.00

FLARE NUT WRENCH FOR CUMMINS DIESEL ENGINE COMMON RAIL INJECTION 24mm

This special 24mm flare nut type wrench will slide back into the recessed area of the cylinder head where the fuel line retainer screws into the head. This tool holds the 24mm retainer in place while you loosen the 19mm coupler to the high-pressure fuel lines.
$49.00

GM DURAMAX CRANKSHAFT AND FLYWHEEL KIT

Servicing GM Duramax diesel trucks with 36mm 12 Point 3/4″ drive impact socket to remove the crank bolt requires a torque of 285 ft. lbs. The 14mm 1/2″drive stubby impact Allen socket aids the technician in removal and installation of the flywheel. Torque specs are 58 ft. lbs. plus 120° of torque angle.
$44.00

GM DURAMAX FLYWHEEL LOCK

Holds flywheel in place when removing or replacing the crankshaft bolt. Simply remove the inspection window cover on the transmission, slide the flywheel lock tool through the inspection window until flywheel is engaged for removal of crankshaft.
$29.00